Jeep Wrangler 4xe Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
14 Posts
I installed the kit myself and had the dealer update the system when they performed the software update required by Jeep.
The only issue I had was the placement of the relay module, it didn't really fit where they wanted it to.
They showed the harness doubling back to the passenger side somewhere.
I ended up Zip tying on the drivers side fender well.
The programming update in Uconnect took a couple of power cycles to appear correctly but has been there consistently since then.
i haven't tied in any of the power leads yet to confirm their correctness but they seem to program properly.
 
1 - 1 of 1 Posts
Top